CCS and Power Systems

Carbon Capture - Post-Combustion Capture

Novel Concepts for the Compression of Large Volumes of Carbon Dioxide

Performer: Southwest Research Institute

Project No: FC26-05NT42650

Program Background and Project Benefits

The mission of the U.S. Department of Energy/National Energy Technology Laboratory (DOE/NETL) Carbon Capture Program is to develop innovative environmental control technologies to enable full use of the nation’s vast coal reserves, while at the same time allowing the current fleet of coal-fired power plants to comply with existing and emerging environmental regulations. The Carbon Capture Program portfolio of carbon dioxide (CO2) emissions control technologies and CO2 compression is focused on advancing technological options for the existing fleet of coal-fired power plants in the event of carbon constraints.

Studies conducted by DOE have revealed the high cost and energy requirements that exist for CO2 compression. The CO2 captured from a power plant will need to be compressed from 1,500 to 2,200 pounds per square inch absolute (psia) to be effectively transported via pipeline and injected into an underground sequestration site. This compression requires significant power and the penalty can be as high as 8 to 12 percent for pulverized coal (PC) plants and 5 to 7 percent for a typical integrated gasification combined cycle (IGCC) plant. Reduction of the compression cost and energy requirements will benefit the overall efficiency of carbon capture and storage (CCS) for utility applications.

The concepts developed in this project can significantly reduce the cost of pressurizing CO2 to pipeline requirements and improve the overall efficiency of CCS systems for all types of power plants. Successful completion of the Phase III project effort should advance the technology to the point of field demonstration testing.

Primary Project Goal

The project goal is to examine methods to pressurize CO2 to pipeline pressures while significantly decreasing parasitic energy consumption, assisting central power plants to capture and store CO2 economically.


The project objectives are to advance CO2 compression and pumping technology to provide double digit power savings compared to a conventional compressor. These efforts are aimed at advancing and evaluating an in-line, multi-stage, internally-cooled centrifugal compressor in a pilot-scale plant in order to improve the mechanical reliability compared to integrally geared compressors. The design will be scalable to accommodate 1000 MW class power plants.

Planned Activities

Phase I:

  • Conduct a thermodynamic and economic analysis to determine the preferred CO2 state for pressurization.

  • Identify and evaluate intercooling concepts, develop preliminary intercooling designs, and calculate total potential energy savings.

  • Complete a comprehensive thermodynamic and cost analysis of an IGCC plant incorporating the new pressurization technology.

Phase II:

  • Design and fabricate a two-stage intercooled compressor test rig based on the analyses and design studies. The flow path will be designed using state-of-the-art turbomachinery design tools and computational fluid dynamics (CFD).

  • Verify and optimize performance of the intercooled compressor test rig.

  • Design and fabricate a multi-stage pump test rig based on the analyses and design studies.

  • Verify and optimize the multi-stage pump test rig.

Phase III:

  • Design and construct a pilot-scale demonstration of a multi-stage centrifugal compressor with cooled diaphragm technology.

  • Establish and apply a rigorous performance testing and monitoring program to determine if overall power savings targets are achieved.

  • Develop and test a third-generation cooled diaphragm design for even greater performance.

Project Details